BENRUBI CM 6626A, Manual

Page: 25 / 28

26
EN
Εspresso Maker
CM 6626A
• Mix adequate descaler with cold water in
a measuring jug as per its instructions. Fill
the water tank up to the Max level with the
prepared descaling solution.Then put the
water tank back into the machine.
• Make sure the filter holder is not attached
and put a bowl with a capacity of at least
1500ml under the boiler outlet to collect the
descaling solution.
• Press down the On/Off button and wait until
the ready light glows.
• Press down the coffee/hot water button and
allow half the solution to flow out, seriatim
release the coffee/hot water button and the
On/Off button to the off position to stop the
flow.
• Leave the machine to rest for 15 minutes,
then seriatim press down the On/Off button
and the coffee/hot water button until the
water tank is empty.
• Thoroughly rinse the tank.
• Fill the water tank with cold fresh water up
to the Max level again and repeat steps 2
to 5 without rest to rinse the appliance for
twice.

NoTE : Always rinse the machine by letting
it empty at least two full water tanks.
Seriatim release the coffee/hot water button
and the On/Off button to off position.
IMPoRTANT
:
• Never interrupt the descaling process.
• Repairs caused by malfunctioning due to
scale deposited inside the appliance are not
covered by the guarantee if the descaling
process is not carried out properly.
Troubleshooting
• If you have a problem, you may find the
solution in the table below. If the table does
not provide the solution to your problem,
please contact with the nearest authorized
BENRUBI service agent for examination,
repair or adjustment.