BENRUBI CM 6626A, Manual

Page: 22 / 28

23
EN
Εspresso Maker
CM 6626A
• Remove the filter holder by turning to the
left.
• There will be water on the filter when you
remove it, this is normal.
• To remove the used coffee from the filter
holder, please lift the plastic pressing block
to press the edge of filter as shown , then tip
the filter holder upside down and tap out the
grounds.
IMPoRTANT
:
You can not start to make espresso until the
ready light glows because it means the water
temperature is not enough when the ready
light goes out.
To avoid water leakages from the rim of filter
holder and to ensure optimum performance, it
is necessary to clear any ground coffee from
around the boiler outlet. Take care as the
area may be hot.
To Make Espresso Using Filter Pods
• Preheat the machine as above ‘Preheating
the espresso machine’. Fit the small filter
into the filter holder before fitting to the
machine.
• Place the coffee pod into the filter making
sure the pod is facing the correct way.
• Press the pod towards the lower part of
the filter, making sure that the paper flaps
adhere to the inner part of the filter.
• The pod needs to be well centred and
placed in the filter.
• Fit the filter holder into the boiler outlet and
turn to the right until it locks into position.
• Follow as the steps 5 to 8 of the chapter ‘To
make espresso using ground coffee’.
IMPoRTANT
:
1) Use pods with 44-45 mm diameter.
2) Always follows the instruction on the
package of the pods for the correct
positioning of the pods in the filter.
To Froth Milk for Cappuccino
• Prepare the espresso as previously
described.
• Make sure there is water in the tank.
• Press down the steam button, the steam
light will glow, wait until the ready light glows
indicating that the boiler has reached the
correct temperature.
• Partly fill a jug with milk - the milk may
increase up to three times in volume so
select a suitably sized jug.
• Cold semi skimmed milk gives the best
results.
• Position the jug under the steam/hot water
nozzle.
• Place the nozzle into the milk about 30mm
deep and turn the steam/hot water knob
in an anti clockwise direction, the milk will
begin to increase in volume and appear
frothy. When the volume of the milk has
doubled, fully immerse the nozzle and
continue heating the milk. Once the desired
temperature is reached(60℃ is optimum),
stop the steam by turning the steam/hot
water knob clockwise.

NoTE : When operation in steam mode and
with the steam/hot water knob turned off,
some water may drop from the boiler outlet
or the attached filter holder. This water
collects in the drip tray. Alternatively you
can place a cup under the boiler outlet or
the attached filter holder.
• Release the steam button to the off position,
the steam light goes out.