![background image](http://html1.mh-extra.com/html/benq/wdp02/wdp02_user-manual_2735070009.webp)
9
Introduction
Static red
off
Standby
Power saving
1.If the wireless connection is not established after over 80 seconds, the link might be lost or the transmitter is
most likely out of range. You may have to verify the range and adjust or shorten the distance between the
transmitter and the receiver. The maximum video transmission range for 1080p content is up to 20 m (66 feet)
in line of sight (LOS), and the minimum range is 1.98 m (6.5 feet). Transmission distance varies from
environments. Stated distance is based on line-of-sight measurement. Structures constructed of steel, wood,
concrete, or brick may decrease transmission distance.
2.Please make sure the source devices have been turned on and switched the signal output to HDMI out; also try
to re-plug the HDMI cable to make sure the HDMI connector had settled well.
3.If there is no video displayed and OSD displayed
, this is an indication that the video frame rate from the
computer is not supported. Please refer to
Supported resolution on page 22
to switch a supported video
timing.
4.If you have more than one set of the unit, each transmitter and receiver should be at least 1.98 m (6.5 feet)
away from one another.
Power indicator
(on Rx)
Source indicator
(on Rx)
OSD Display
(on Rx)
Item/Mode
Status Description