17
Installation
4. Press
SOURCE
button on the remote control or on the top of the receiver/the transmitter for
source input switching until you see the video being transmitted.
Performing IR sync
The default IR blaster frequency setting is 47KHz, which is compatible with most remote controls.
With the connected IR blaster cable, it relays infrared commands from your remote control to the
connected source devices. After all the devices have been installed and powered on, you should be
able to control your source devices by pointing their remote control to the receiver. If one of your
source devices does not respond, follow the procedures to perform IR sync to set the IR frequency.
1. Place two AAA batteries into the remote control of the receiver/transmitter.
2. Make sure that the IR blaster cable has been connected with source devices and transmitter. See
Setting up the transmitter (Tx) on page 10
for details.
3. Make sure that the transmitter, receiver, and all the connected devices have been properly
connected and powered on, and the desired source has been transmitted. See
Powering up all
devices and making source selection on page 16
for details.
4. Press the
IR
button on the receiver’s remote control. The current IR frequency is displayed.
Press the
IR
button again to set to a different IR frequency. See
Change IR blaster frequency on
page 19
.
