![background image](http://html1.mh-extra.com/html/benq/wdp02/wdp02_user-manual_2735070019.webp)
19
Basic operations and on-screen display (OSD)
Basic operations and on-screen display (OSD)
Only the status of the receiver connected to the projector can be displayed on the OSD. The status of the
transmitter HDMI out cannot be displayed.
Function
Operations
OSD display
Both Rx and
Tx enter
standby mode,
while Tx’s
HDMI out is
on
In active mode, press the power button on the
top of the receiver / transmitter or on the
remote control pointing to the receiver, both the
transmitter and the receiver will enter standby
mode while the transmitter’s HDMI out is still
on.
ON
(display for 3 seconds and then
enter standby mode.)
Shows display
information
Press the
INFO
button on the remote control,
and information such as signal quality, source,
channel, and resolution will be displayed for
reference.
Press the
INFO
button again to exit.
= OFF
Audio / video
source input
selection
Press the
SOURCE
button on the remote
control or on the top of the transmitter (or the
receiver) for audio/video source input selection.
Example:
HDMI1 CH10 1280x1024
Change IR
blaster
frequency
Press the
IR
button of the remote control to
change IR blaster frequency between 36KHz and
56KHz. The default IR blaster frequency setting
is 47KHz.
• Press once for current IR frequency status
display.
• Press again to switch IR blaster frequency.
Example:
HDMI1 CH10 1280x1024
=
38KHZ