Operation
35
English
Setting the User 1/User 2 mode
There are two user-definable modes if the current available picture modes are not suitable
for your need. You can use one of the picture modes (except the
User 1
/
User 2
) as a starting
point and customize the settings.
1.
Press
MENU/EXIT
to open the On-Screen Display (OSD) menu.
2.
Go to the
PICTURE
>
Picture Mode
menu.
3.
Press /
to
select
User 1
to
User 2
.
4.
Press
to highlight
Reference Mode
.
This function is only available when User 1 or User 2 mode is selected up in the Picture Mode
sub-menu item.
5.
Press
/
to select a picture mode that is closest to your need.
6.
Press
to select a sub-menu item to be changed and adjust the value with
/
.
See
"Fine-tuning the image quality in user modes"
below for details.
7.
When all settings have been done, highlight
Save Settings
and press
MODE/ENTER
to store the settings.
8.
The confirmation message '
Setting Saved
' displays.
Fine-tuning the image quality in user modes
According to the detected signal type, there are some user-definable functions available
when
User 1
or
User 2
mode is selected. You can make adjustments to these functions
based on your needs.
Adjusting Brightness
Highlight
Brightness
in the
PICTURE
menu and adjust the values by pressing
/
on
the projector or remote control.
The higher the value, the brighter the image. And lower
the setting, darker the image. Adjust this control so the
black areas of the image appear just as black and that
detail in the dark areas is visible.
Adjusting Contrast
Highlight
Contrast
in the
PICTURE
menu and adjust the values by pressing
/
on the
projector or remote control.
The higher the value, the greater the contrast. Use this
to set the peak white level after you have previously
adjusted the
Brightness
setting to suit your selected
input and viewing environment.
+50
+30
+70
0
+30
-30