Operation
31
Correcting Surface Fit
Manually correct geographic distortion by Surface Fit calibration function.
• Using the OSD menu
1.
Press
MENU/EXIT
and then press
◄
/
►
until
the
Display
menu is highlighted.
2.
Press
▼
to highlight
Surface Fit
and press
MODE/ENTER
. The
Surface Fit
page
displays.
3.
Press
▲
/
▼
to select a
Horizontal Surface
Fit
and press
MODE/ENTER
.
4.
Press
◄
/
►
to select the direction and press
MODE/ENTER
.
Only one Surface Fit setting will be stored so if you want to change
from the previous direction to the other, the notice message will
pop-up to remind you to reset the previous Surface Fit setting.
5.
Press
◄
/
►
to adjust the left or/and right side
convex or concave. Default is 0 and value is -40~0~40.
Single side adjustment is only for distortion.
6.
For both sides of the horizontal surface fit, use
▲
/
▼
to
adjust the center of the curve because it is not always at
the center. Default is 0 and value is -40~0~40.
7.
Press
▲
/
▼
to select
Vertical Surface Fit
and
press
MODE/ENTER
.
