9
Installation
3. When the IR blaster cable is connected, it relays infrared commands from your remote control
to the device. You can now control your source devices by pointing their remote control to the
receiver instead.
Setting up the receiver (Rx)
Attaching receiver (Rx) to your BenQ projector with mounting holder-A
The IR sensor supports remote’s signal protocol of NEC, RC5, and RC6 between 36 KHz ~ 56 KHz. Therefore, it
is possible that some devices may not be supported.
1. If your BenQ projector is one of following
models: W1070+, , W1350,
HT1075, or 1085ST, please mount the
receiver to the right hand side of the projector
with the mounting holder-A (L type). Fix one
side of the mounting holder to the tripod hole
on the bottom of receiver and then fix the
other side of the mounting holder to the
bottom of projector by using the supplied
anchor.
2. All of these models mentioned above are
equipped with a USB type A jack (1.5V) to
provide power supply for the receiver. Just
connect one end of supplied USB cable to the
mini USB jack of the receiver and the other
end to the USB type A jack of the projector.
3. Connect the HDMI cable to the
HDMI
out
jack of the receiver and the HDMI input jack
of the projector. Turn on the projector and
the receiver will be automatically turned on
accordingly. The indicator on the power
button of the receiver will light up in blue.
4. Press the source button of the projector to select the appropriate HDMI video input.
USB
HDMI