Using the chlorinator
1. When the chlorinator is connected to the faucet, adjust the water flow with the valve to ensure
that enough water flows through the salt chlorinator.
2. Before use, ensure that the salt concentration of the pool water is within the normal operating
range (3.5- 4.5 kg of salt per m³), otherwise it may shorten the life of the Titanium cell.
3. The display shows the current water temperature. Press the Power / Operate button, the
operation light will change from red to green and the chlorinator will start working: Note: The
chlorinator can only operate if the water level detector detects the presence of sufficient
water flow .
4. By pressing the "+" or "-" button, users can adjust the rate of chlorine creation as needed; users
can use level 1-5, 1 level is the smallest and 5 level is the highest. The higher the level, the
faster the chlorine is produced.
5. Parameter check: press the acceleration key several times while the chlorinator is off to look up
various parameters below:
① Internal temperature chlorinator
② Water temperature
③ Input voltage
④ Version number
⑤ Time period of continuous operation; the system automaticall
y exits the application after
3 seconds
6. Time setting for continuous operation: press the acceleration key 5 times while the machine is
turned off to display the time period of continuous operation. Change the time periods of
continuous operation by pressing '+' or '-'.
The time period ranges from 1-24 hours
(and then shut off) after it is turned on. After this cycle, the chlorinator stops for 12 hours and
turns on again for 12 hours.
In case you use the control option "RX TIME", the setting of the chlorinator should be at least as
long, than the selected time.
IMPORTANT:
THE CHLORINATOR IS PRESET FOR 12 HOURS CONTINUOUS
OPERATION, IF 24 HOURS NON-STOP OPERATION IS REQUIRED, THE TIME
FOR CONTINUOUS OPERATION MUST BE SET TO 24; THE SYSTEM WILL
AUTOMATICALLY EXIT THE SETTING AFTER 3 SECONDS.
