Product Specifications and
Operations Manual
ELT160.60.100-07NC
Transparent Matrix Display
Beneq Oy
Olarinluoma 9
Tel. +358 9 7599 530
VAT ID FI25115461
FI-02200 Espoo
Fax +358 9 7599 5310
www.beneq.com
Finland
www.lumineq.com
Date: October 7, 2019
Document number: ED001129C
Page | 14
3.9
Dimming
Dimming of the display is handled through the communications protocol of the display
(“digital dimming”), or through the LUMA pin (pin #10;
analog dimming).
Analog dimming allows for manually adjustable dimming from 100% to approximately 5% of
the full brightness. To perform analog dimming, connect a 50 kΩ variable resistor between
LUMA and GND. Alternatively, an external voltage or current mode D/A converter may be
used to facilitate dimming by sinking a maximum of 250 μA (for maximum dimming) from
LUMA to GND on the input connector. Open circuit voltage of the LUMA pin is 4 V nominal.
3.10
Environmental
Table 6. Environmental characteristics
Operating
Non-operating
Temperature
Standard
-60 °C to +85 °C
-60 °C to 105 °C
Humidity
40C/93 % RH
(complies with
IEC60068-2-78
standard)
In order to meet these values with the complete system design, including but not limited to
lamination into a windscreen, all materials and processes need to be compliant with these
requirements and values.
3.11
Mechanical characteristics
3.11.1
Display Panel
Table 7. Mechanical characteristics/dimensions of the display
Display external dimensions
millimeters
width
for entire panel, 224 mm
height
90 mm
depth
0.7 mm glass with some 10 us of the
display stack.
Weight (typical)
For glass panel with density 2.53 kg/dm3,
approx. 30 g (without FPC and electronics)
Fill factor
64 % (0.8 mm pixel side with 1.0 mm
pitch)
