Product Specifications and
Operations Manual
ELT160.60.100-07NC
Transparent Matrix Display
Beneq Oy
Olarinluoma 9
Tel. +358 9 7599 530
VAT ID FI25115461
FI-02200 Espoo
Fax +358 9 7599 5310
www.beneq.com
Finland
www.lumineq.com
Date: October 7, 2019
Document number: ED001129C
Page | 13
3.6
Self-test mode
The display incorporates a self-test mode composed of two patterns displayed for
approximately one minute each, and then repeated. The patterns are as follows: Full On and
1 x 1 Checkerboard.
The self-test mode is started at power-on until the first command to the display is detected.
For no self-test at display startup, the SELFTEST pin must be connected to ground.
3.7
Material
Display material is soda lime glass with thin films of the display (DSD stack) and its electrical
structure (ITO traces). ITO thickness is 600 nm.
3.8
Optical
The Display emits a yellow light with peak emission at approximately 582 nm. The luminance
figures below relate to measurements in darkness (no ambient light).
Table 5. Optical characteristics
Luminance
L
on
(areal)
120 cd/m²
screen center, estimate, with a maximum frame rate
Non-uniformity
All pixels fully lit 35 %
Maximum difference two of five points, using the
formula: LNU%=[1- (min_lum/max_lum)] x 100%
Luminance variation (Temperature)
Maximum
±20 %
Across operating temperature range
Luminance variation (Time)
Maximum
<20 %
10,000 hours at 25 °C ambient
Viewing angle
Both sides
179°
Transparency (optically bonded to clear glass)
Photopic
Transparency
>70 %
Pixels
Pixel pitch
1 mm x
1 mm
Pixel size
0.8 mm x
0.8 mm
leading to fill factor 64 %
Pixel amount
160 rows
and 60
columns
