139
Emission provision
CO
HC
NO
X
Emission standard
≤2.0g/km
≤0.3g/km
0.5 g/km
16.2 Regular Maintenance Notes
The state gives provisions for motor vehicles to conform gas pollutant emission standards to all
manufacturers to ensure that the environmental pollution
doesn’t get worse. Apart from keeping
with the gas pollutant emission standard in our production, our company makes great effort in
gas purification and gas pollutant reduction.
This motorcycle undergoes strict examination before leaving the factory with all qualities in
conformity with gas pollutant emission standards. We formulate the regular check list
concerning gas emission as follows in consideration of different use condition by customers.
The use is requested to carry out regular checks, adjustments or maintenance according to the
scheduled time to ensure normal emission.
If other problems occur, please contact Benelli distributors or a Benelli service center for help.
Relevant Emission provisions are shown as follows:
*
If any changes about Emission provision, the latest national provision shall prevail.
The company is not responsible for the ban of motorcycles that do not receive regular
maintenance according to Benelli distributors or Benelli service center. Please do the necessary
check frequently so as to keep a good motorcycle condition.
Note:
①
Increase frequency of washing air filter if your motorcycle runs on sandy/gravel roads or
under heavily polluted environments so as to extend its service life.
②
Motorcycles which often run at high speed or with high mileage shall be maintained frequently.
Please pay attention to the following to make Emission meet standard:
1)
Use of fuel: please use lead-free gasoline.
2)
Please use defined machine oil.
3)
Maintain the vehicle according to the regular maintenance table.
4)
As to the exhaust gas emission control system, arbitrary adjustment or replacement is forbidden
(including adjustment on the use of spark plug, idle speed, ignition timing, etc).
5)
Cautions:
Since the disorder of ignition system, the charging system, and the fuel system has great
influence on the catalytic system, please come to designated distributors or service center
of our company for examination, adjustment or maintenance if any disorder of the above ones
occurs.
6)
The exhaust gas emission control system of the vehicle is in line with relevant provision of our
country, make sure to use the quality components of our factory if needed, and receive
service from designated distributors and service centers.
Summary of Contents for ZAFFERAN 250
