Benelli TRK 502, Service Station Manual

Page: 159 / 408

4 - 65
Lubricate:
• The bearings Fig. A.
• The dust seal rings Fig. A.
• The races of the bearings Fig. A.
G
RECOMMENDED LUBRICANT
MR2 TUTELA GREASE
Install:
• The steering ring nut (2) Fig. C using the special tool
to the following torque:
T.R.
Torque 16 N*m
(**) Tool to tighten the steering sleeve lock nut
Code: R180297129000
IMPORTANT NOTICE
Do not overtighten the steering ring nut.
• the steering ring nut (1) Fig. C
• Position the upper steering base (9*) Fig. B
• the cap (4*) Fig. B (using the special tool) and tighten to the
following torque pressure:
T.R.
Torque 60 N*m
• the set screws (3*) Fig. B to the following torque pressure:
T.R.
Torque 22 N*m
Check:
• The steering sleeve Fig. C.
Gently oscillate the front fork, holding it by the ends of the tubes.
If there is any jamming/loosening, adjust the steering sleeve.
STEERING HEAD
TOP AND BOTTOM STEERING BASE FITTING
A
B
4*
3*
3*
C
C
1
9*
2
COPY - Moto GB - Grant Martland - grantmartland@motogb.co.uk