Benelli TRK 502, Service Station Manual

Page: 105 / 408

4 - 11
FRONT WHEEL AND BRAKE DISCS
FRONT WHEEL INSTALLATION
Install:
• the wheel between the two tubes of the fork Fig. A
• the bush (8*) – left side Fig. A
• the bush (3*) – right side Fig. A
Tighten the torque:
• wheel axle (6*)
G
Recommended lubricant
MR2 TUTELA GREASE
T.R.
Torque 60 N*m
• Set screws “B” Fig. B
T.R.
Torque 8 N*m
IMPORTANT NOTICE
Before tightening the front wheel axle bolt, push hard on the
handlebars to check that the front fork returns to the station-
ary position in a smooth way.
Install:
• right brake calliper Fig. C
• tube guide bracket Fig. C
• screw (E) Fig. C
• ABS sensor (A) Fig. C
• screws (B) Fig. C
Tighten the torque:
T.R.
Torque 50 N*m
NOTE:_________________________________
Repeat the above-mentioned procedure for the opposite
brake calliper.
Ensure that there is enough space between the brake pads
before fi tting the callipers on the relative brake discs.
Check that the travel of the fl exible brake hose is correct.
NOTE:_________________________________
The numbers marked (*) are a part of the table at the begin-
ning of the chapter.
A
3*
6*
B
B
8*
C
B
A
C
E
COPY - Moto GB - Grant Martland - grantmartland@motogb.co.uk