BendPak LR-10000, Installation And Operation Manual

Page: 33 / 44

LR-10000 Low-Rise Scissor Lift
33
P/N 5900075 — Rev. A1 — April 2019
If the Vehicle
is
stable and balanced, it is safe to raise further.
⚠
DANGER
Do not raise the Lift further until you are certain the Vehicle on the Lift is both stable
and balanced. If the Vehicle is
not stable and balanced, it could fall, which could
damage the Vehicle, damage the Lift, or injure or kill anyone under the Vehicle.
13. On the Power Unit, press and hold the
Raise
button.
14. Watch the Vehicle and the Platforms as they rise.
If the Lift becomes unstable or the Vehicle starts moving, release the
Raise button immediately.
15. When the Platforms are just past the desired height, release the
Raise
button.
The Lift stops rising.
16. Press the Lowering Handle to move the Platforms back down, which engages them on the most
recently passed Safety Lock.
If you miss the Safety Lock, press and hold
Raise again and go somewhat further past the Safety
Lock, then hold the Lowering Handle again to engage the Lift on the Safety Lock.
Lowering a Vehicle
This section describes how to lower a Vehicle from a raised position.
To lower a Vehicle :
1. Check the items listed in Lift Operation Safety .
If you find any issues, resolve them before lowering the Vehicle.
Only use the Lift if it can be used safely
.
2. Press and hold the
Raise
button for a second or two.
This moves the Platforms off the Safety Lock.
3. Move the Safety Lock Release Handle to the Raised position.
This pushes the Safety Lock Bar up, allowing the Safety Locks to be passed by.
4. Press and hold the Lowering Handle.
5. Release the Lowering Handle when the Lift is fully lowered.
6. Move the Safety Lock Release Handle back to the Lowered position.
7. Carefully drive the Vehicle off.