33
2. Raise the lift off of the Safety Locks by pressing the
push button on the Power Unit. Make sure you raise the
lift by at least two inches to allow adequate clearance for
the locks to clear.
3. Press the push button air safety valve and HOLD.
4. Push the LOWERING HANDLE on the Power Unit
until the lift has descended completely.
DAILY MAINTENANCE
1. Make a visual inspection of ALL MOVING PARTS and
check for excessive signs of wear.
2. Check safety locks to ensure they are in good operat-
ing condition.
3. Check cables and sheaves for wear. Replace worn
parts as required with genuine BendPak parts.
4. Inspect adapters for damage or excessive wear. Re-
place as required with genuine BendPak parts.
WEEKLY MAINTENANCE
1.
Lubricate all Sheave and rollers with general
purpose oil.
2. Check all Cable connections, bolts and pins to
ensure proper mounting.
3. Lubricate Safety Lock pivot points with general pur-
pose oil or WD-40.
MONTHLY MAINTENANCE
1. Check Safety Locks to ensure they are in good
operating condition.
Lubricate locking latch shafts. Push
release arm several times for oil to penetrate pivot
points.
2.
Check equalizer cable tension. Adjust per lift installa-
tion instructions.
3. Check all Cables for excessive signs of wear.
4. Make a visual inspection of ALL MOVING PARTS
and check for excessive signs of wear.
• Always call local service representative if electrical
problems develop.
• Always
replace ALL FAULTY PARTS before lift is put
back into operation.
• Every 3 Months: Check anchor bolt torque. Anchors
should be torqued to 90 Pound Feet.
• Semi-Annually: Check fluid level of lift power unit and
refill if required per lift installation instructions.
• Replace all caution, warning or safety related decals
on the lift if unable to read or missing. Reorder
labels
from BendPak.
• Refer to ANSI/ALI ALOIM booklet for periodic
inspection checklist and maintenance log sheet.
CAUTION!
IF YOU ARE NOT COMPLETELY FAMILIAR WITH AU-
TOMOTIVE LIFT MAINTENANCE PROCEDURES; STOP
AND CONTACT THE MANUFACTURER FOR INSTRUC-
TIONS. TO AVOID PERSONAL INJURY, PERMIT ONLY
QUALIFIED PERSONNEL TO PERFORM MAINTENANCE
ON THIS EQUIPMENT.
LIFT OPERATION SAFETY (CONT’D)
