14
STEP 6
(Off Side Ramp Installation)
3. Position the OFF SIDE RAMP on top of the crosstubes
with the UTILITY RAIL located inside. Align the holes in
the ramp with the holes on the crosstubes and bolt togeth-
er (torque to 35-45 Ft/lbs) using four M12 x 1.75 hex bolts,
nuts, and washers. (See Fig. 6.1)
STEP 7
(Cable / Sheave Installation)
1. Inspect cables to ensure proper lengths. All
CABLES
should have ID tags showing proper cable lengths.
2. In order to install the cables, it is necessary to first
extend the HYDRAULIC CYLINDER. Remove both
cylinder port plugs, then use an rubber tipped air gun or
ratcheting pull-strap to extend the cylinder.
IMPORTANT!
Be careful not to damage the chrome rod during this step.
(See Fig. 7.1)
Bolt Points
Fig 5.3
Fig 6.1
Utility Rail
Bolt Points
DANGER !
DO NOT PROCEED
WITH CABLE INSTALLATION OR
GO NEAR THE LIFT WORK AREA UNLESS VISUAL
CONFIRMATION IS MADE OF ALL SAFETY LOCKS
BEING ENGAGED. ALL LOCKS MUST BE ENGAGED
BEFORE PROCEEDING. FAILURE TO COMPLY WITH
THESE INSTRUCTIONS MAY RESULT IN SEVERE
PERSONAL INJURY OR DEATH. (SEE PAGE 28)
WARNING!
WHEN THE CABLE ADJUSTING NUTS BOTTOM
OUT ON THE THREADED END OF THE CABLE
CONNECTOR AND THERE IS STILL SLACK IN
THE CABLES, THE CABLES HAVE STRETCHED
BEYOND THE SAFE USEFUL LENGTH AND NEED
TO BE REPLACED WITH FACTORY APPROVED
CABLE ASSEMBLIES. DO NOT PLACE WASHERS,
SPACERS OR OTHER DEVICES TO “SHORTEN” THE
EFFECTIVE CABLE LENGTH AS DAMAGE TO THE
LIFT OR INJURY TO PERSONS MAY OCCUR.
WARNING!
IF USING RUBBER-TIPPED AIR GUN, DO NOT
EXCEED 50 PSI. IF CYLINDER DOES NOT MOVE,
IMMEDIATELY DISCONTINUE USE OF AIR GUN AND
USE RATCHETING PULLSTRAP OR OTHER PULLING
DEVICE. KEEP HANDS CLEAR.
Fig 7.1
Apply Compressed
Air Here With Rubber
Tipped Air Gun
