ALWAYS WEAR SAFETY GOGGLES.
4. Assemble the Washers and Nuts on the anchors
then tap each hole with a hammer until the washer rests
against base plate. Be sure that if shimming is required,
enough threads are left exposed. (See Fig. 15.3)
5. If shimming is required, insert the shims as neces-
sary under the base plate so that when the anchor bolts
are tightened, the columns will be plumb. (See Fig. 15.4)
6. After any necessary shims are installed, tighten each
nut 3-5 turns past hand tight. IMPORTANT - If anchor
bolts do not hold when tightened to indicated amount,
concrete must replaced. Saw cut and remove 24” x 24”
square area each column base then re-pour with rein-
forced 2500 PSI concrete to a depth of six inches mini-
mum, keying new concrete under existing floor. (See Fig.
15.5)
STEP 16
(Attaching the Approach Ramp /Tire Stops)
1. Install the Front Tire Stops at the forward side of the
lift. Slide the Tire Stop Pin through the Ramp and the
Tire Stop. (See Fig. 16.1)
2. Install the Approach Ramps on the entry side of the
lift. (See Fig. 16.2)
29
Fig 15.3
Fig 15.4
Fig 15.5
Fig 16.2
Fig 16.1
