6
1. Carefully remove the crating and packing
materials.
CAUTION!
Be careful when cutting steel
banding material as items may become loose and fall
causing personal harm or injury.
2. Check the voltage, phase and proper amperage
requirements for the motor shown on the motor plate.
Wiring should be performed by a certified electrician
only.
IMPORTANT SAFETY INSTRUCTIONS !
Read these safety instructions entirely!
IMPORTANT NOTICE !
Do not attempt to install this lift if you have never been trained on basic automotive lift installation procedures.
Never attempt to lift components without proper lifting tools such as forklift or cranes.
Stay clear of any moving parts that can fall and cause injury.
INTRODUCTION
1.
READ AND UNDERSTAND
all safety warning
procedures before operating lift.
2.
KEEP HANDS AND FEET CLEAR
. Remove hands and
feet from any moving parts. Keep feet clear of lift when
lowering. Avoid pinch points.
3.
KEEP WORK AREA CLEAN
. Cluttered work areas
invite injuries.
4. Consider work area environment. Do not expose
equipment to rain.
DO NOT
use in damp or wet locations.
Keep area well lighted.
5.
ONLY TRAINED OPERATORS
should operate this lift.
All non-trained personnel should be kept away from work
area. Never let
non-trained personnel come in contact with,
or operate lift.
6.
USE LIFT CORRECTLY
. Use lift in the proper manner.
Never use lifting adapters other than what is approved by the
manufacturer.
7.
DO NOT
override self-closing lift controls.
8.
REMAIN CLEAR
of lift when raising or lowering vehicle.
9.
CLEAR AREA
if vehicle is in danger of falling.
10.
ALWAYS INSURE
that the safeties are engaged before
any attempt is made to work on or near vehicle.
11.
DRESS PROPERLY
. Non-skid steel-toe footwear is
recommended when operating lift.
12.
GUARD AGAINST ELECTRIC SHOCK
. This lift must
be grounded while in use to protect the
operator from electric shock. Never connect
the green power cord wire to a live terminal.
This is for ground only.
13.
DANGER!
The power unit used on this lift contains high
voltage. Disconnect power at the receptacle
before performing any electrical repairs.
Secure plug so that it cannot be
accidentally plugged in during service.
14.
WARNING! RISK OF EXPLOSION
. This equipment
has internal arcing or sparking parts which
should not be exposed to flammable vapors.
This machine should not be located in a
recessed area or below floor level.
15.
MAINTAIN WITH CARE
. Keep lift clean for better and
safer performance. Follow manual for proper lubrication
and maintenance instructions. Keep control handles and/or
buttons dry, clean and free from grease and oil.
16.
STAY ALERT
. Watch what you are doing. Use common
sense. Be aware.
17.
CHECK FOR DAMAGED PARTS
. Check for alignment
of moving parts, breakage of parts or any condition that may
affect its operation. Do not use lift if any component is broken
or damaged.
18.
NEVER
remove safety related components from the lift.
Do not use lift if safety related components are damaged
or missing.
Summary of Contents for HD-14
