Bender UNIMET 300ST, Operating Manual

Page: 19 / 62

Operation and configuration
19 TGH1365en/10.2012
4.5 Device settings
Some of the following settings are used in generating reports to record the test
results. You should therefore check these settings before carrying out the first test.
To access the device settings:
Menu item Function Page
1. Exit Returns to the main menu -
2. Test probe calibration Zero calibration test probe 20
3. Device type query This is where you determine whether another device type
is to be queried and stored in addition to the device ID. 21
4. Warm-up/cool-down Setting for devices which require a warm-up period before
the test and cool-down period after the test. 21
5. Change comp. name The company name entered here will appear on the
printout of the test report and after switching on the
device on line 4 of the welcome menu. 22
6. Time/date Set system time and date 22
7. RS-232 parameters Set data transfer speed 23
8. Buzzer On/Off Switch buzzer on or off
24
9. Summer/wintertime Automatic switchover from summer time to winter time 24
10. Language/Sprache Select German or English for user menus and protocol
text. Activate settings for use in Austria. 25
11. Firmware update Load new version of operating software 25
Main menu
1. Select “Device setting”
ESC
2. Select required function
1. Exit
2. Test probe calibr.
3. Device type query
4. Warm-up/cool-down
2. Device catalogue
3. Single test
4. Test eng. catalog.
5. Device setting