Operation and configuration
24
The interface cable supplied (null modem cable or USB1.1-RS-232 converter) is required for the data
transfer. The data transfer is always initiated by the PC software. No operation is required on the test
system for this to happen. For further information, please see the instruction manual for the PC
software.
4.5.7 Buzzer On/Off
Proceed as follows to turn the UNIMET
®
300ST buzzer on or off:
4.5.8 Summer time/winter time
Proceed as follows to select whether the switchover from summer time to winter time should occur
automatically:
Automatic switchover from summer time to winter time applies to most European countries
(exceptions are e.g. England). Turn off the automatic switchover when using the test system in areas
where this time change does not apply.
The data transfer may not start if just one measurement or single test is carried
out.
Failure to observe this requirement may damage the UNIMET
®
300ST and any de-
vice under test connected to it.
Caution
Device setting
1. Select “Buzzer On/Off”
2. Select setting for “Buzzer”
1. Exit
2. Buzzer: On
5. Change comp. name
6. Time/date
7. RS-232 parameters
8. Buzzer On/Off
ESC
Device setting
1. Select “Summer/wintertime”
3. Select “On” or “Off”
2. Select “Auto. switchover
from summer to winter
time”
1. Exit
2. Auto. switchover
from summer to
winter time: On
1. Exit
2. Auto. switchover
from summer to
winter time: On
6. Time/date
7. RS-232 parameters
8. Buzzer On/Off
9. Summer/wintertime
ESC
ESC
Summary of Contents for UNIMET 300ST
Page 50: ...Testing and measuring 50 TGH1365en 10 2012...
Page 58: ...Data 58 TGH1365en 10 2012...
Page 61: ......
