Bender UNIMET 300ST, Operating Manual

Page: 41 / 62

Testing and measuring
41 TGH1365en/10.2012
5.2 Recurrent test and device catalogue
The test results, tests and limits of the device tested by UNIMET
®
300ST can be stored in the device
catalogue. In the case of recurrent tests, the devices are simply called up in the device catalogue and
tested again. Other functions are print report, display results, delete device or delete entire cata-
logue.
The content of the device catalogue can be transferred to a PC program. Similarly, data records se-
lected in the PC program can be transferred to the device catalogue. These functions are described
in the PC software guide.
Proceed as follows to use the device catalogue:
*1 If "device type query" in the device settings is enabled, then the device type is displayed
on the last line for approximately 2 seconds when scrolling in the device catalogue.
*2 If "device type query" in the device settings is enabled, an additional menu item "Change
device type" will also appear.
Test results
are printed
Please wait !
Test device
Main menu
1. Select “Device catalogue”
- Select device
- Print out all test logs
- Delete catalog:
after the prompt, all entries
are deleted
2. Select required function:
3. Select ID No.
,
select next or previous device
Confirm selection
( 1/ 5)
shows the position
in the memory and
the number of devices
----- ID SELECTION -----
ID: ( 1/ 5)
XY47123456
Select: , Confirm:
View results Print test report Delete device
** Note **
Connect DUT to
Unimet a. switch on!
Start:
The selected ID
will be deleted from
the catalogue
Please wait !
Test starts
4. Select action
,
select next
or previous
test step
back to
previous menu
TEST-RESULTS
Total result:
PASS
Select: , Cont.:
*2
*1
1. Exit
2. Select device
3. Collective print
4. Delete catalogue
1. Exit
2. Test device
3. Print test report
4. View result
5. Delete device
6. Change dev. type
1. Classification
2. Device catalogue
3. Single test
4. Test eng. catalog
ESC
ESC