Bender ATICS-2-63A-ISO, Manual

Page: 43 / 104

ATICS-2-ISO_D00046_04_M_XXEN / 03.2021 43
ATICS-2-63A-ISO
4.2.9.7 Bypass switch (optional)
The ATICS-BP-… bypass switch makes it possible to test and change the ATICS® transfer switching and
monitoring device without interrupting the power supply to the line downstream of the transfer
switching device. To make settings, refer to chapter „Operation with bypass switch“ on p. 90.
4.2.10 Fastening, inserting and securing connections
Connect the terminals according to the wiring diagram to the plug connectors (A, B) and the three con-
nector plugs (C).
• Connect lines 1, 2 and 3 to the plug connectors (A,B). Observe the stripping length of 20 mm
and do not use ferrules. Use a Torx® screwdriver T20 or a slotted screwdriver of 6.5 x 1.2 mm.
Tightening torque: 2.5 Nm (≤ 25 mm²) or 4.5 Nm (≥ 25 mm²). Ensure that the lines are
short-circuit and earth-fault proof!
• Use a slotted screwdriver of 2.5 x 0.4 mm to connect the three connector plugs (C). Stripping
length: 7 mm. Tightening torque: 0.22…0.25 Nm.
1. Insert bottom green plug connector (B) and secure with mounting screws. After that, insert
top green plug connector (A) and secure with mounting screws.
2. Insert the three connector plugs (C).
i
ATICS…400 only: Plug the connector into the top (opposite side of C).
i
Only " -ES" version of ATICS®: Connect the ATICS-ES energy storage device using the cable supplied.
4.3 Other functions
4.3.1 Sealing the transparent cover
The transparent cover can only be sealed when it is closed (automatic
mode).
C
A
B
N N