3
3 HARDWARE INSTALLATION
The PDX3000/LDX9000/LTX9000/LDX1000 family of universal line displays has been pre-
assembled to make the installation as simple as possible. Please follow steps below for
models of different interfaces.
3.1 Steps For Hardware Installation
3.1.1 Serial interface displays
Mount the pole display to the metal base plate using the mounting hardware provided.
The pole display can be used in a freestanding mode or attached to the counter using
the remaining mounting hardware.
Connect the DB9F connector to the computer’s serial port (for example, COM1 or
COM2) if serial interface model is used.
For serial pass-through model, connect the DB25M connector to the peripheral device
and turn on power of the peripheral device.
Connect the female power jack of the power adapter to the male power jack of the
interface cable.
Plug the power adapter into a 120VAC outlet.
A start up text message will be present for a short time to identify the selected
command set and selected baud rate. When this message disappears the cursor will be
displayed at the left-most digit of the top row.
3.1.2 USB interface displays
Mount the pole display to the metal base plate using the mounting hardware provided.
The pole display can be used in a freestanding mode or attached to the counter using
the remaining mounting hardware.
Install USB driver following instructions on "USB DRIVER INSTALLATION"
section.
Plug the USB cable from the pole display into the computer’s USB port.
For double sided USB pole displays, connect the female power jack of the power
adapter to the male power jack of the interface cable and plug the power adapter into a
120VAC outlet.
A start up text message will be present for a short time to identify the selected
command set. The test message will NOT be present until USB driver is installed
correctly. When this message disappears, the cursor will be displayed at the left-most
digit of the top row.
