Bellman & Symfon BE9024, Installer'S Manual

Page: 9 / 14

83
84
Settings
The buttons for sensitivity and delay are located on the baby monitor’s left
side. When you press the button, the LED shows the current setting. Then press
repeatedly to adjust the setting.

If the baby monitor isn’t activated when the baby cries – increase the sensitivity.
If the baby monitor is activated too easily – reduce the sensitivity.

If the baby monitor is activated too fast or too slow – adjust the delay.
Sensitivity
Red LED High
Orange LED Medium
Green LED Low
Delay
Red LED 30 s
Orange LED 10 s
Green LED 1 s
Transmitter rce Receiver
Source LED LED Sound Vibration Flash
Baby Green, top Orange Baby melody Rapid pattern Yes
Contact mat Green, bottom Green 1 x ding dong, Lo Slow pattern Yes
Baby Green, top Orange Baby melody Slow pattern Yes
Contact mat
Green, bottom Green 1 x ding dong, Lo Slow pattern Yes
Default indication and signal
Transmitter indication
When the baby monitor is activated, the LED indicator lights up in green. This
means that the batteries are in good condition. Change batteries if the LEDs blink
in orange. Only use 1.5 V AA (LR6) lithium or alkaline batteries.
Receiver signal
When a receiver is activated, it signals with sound, flashes or vibrations. The
default signal pattern is as follows:
Signal pattern

868/315 MHz

433 MHz