29
Ring delay
You can set the number of times the answering machine would ring before it answers the call. This only applies when
the answering machine is turned on.
User can adjust the toll saver to change the amount of rings emitted before the answer machine responds. You can set
the number of rings from 2 rings to 7 rings or toll saver.
The toll saver option is useful when using the remote access feature (see page 30). When the t
oll saver
ts
is
selected, the answering machine will ring four times if no new messages are recorded or two times if there is at least
one new message. We advise you to hang up after the third ring if you want to check if you have any new message at no
cost.
To review the current ring delay setting,
Press the
RING
key during standby. Current setting will be displayed.
To change the ring delay setting,
1. Press
the
RING
key for 2 seconds. Current setting will be blinking.
2. Use
the
VOLUME UP
key and the
VOLUME DOWN
key to adjust the number of rings.
3. Press
the
RING
key again to confi rm. The new setting will be displayed for 2 seconds.
Remote access code
A three-digit code is required for remote access (see page 30). The factory preset code is “000”. You can change it to a
unique code of your own.
To review the remote access code,
Press the
CODE
key during standby mode. The display blinks for a short period of time before
showing the next digit.
To change the remote access code,
1. Press
the
CODE
key for 2 seconds during standby.
2. Use
the
VOLUME UP
key
and the
VOLUME DOWN
key
to change the fi rst digit.
3. Press
the
CODE
key to confi rm the fi rst digit.
4. Use
the
VOLUME UP
key
and the
VOLUME DOWN
key to change the second digit.
5. Press
the
CODE
key to confi rm the second digit
6. Use
the
VOLUME UP
key
and the
VOLUME DOWN
key to change the third digit.
7. Press
the
CODE
key to confi rm the third digit.
Two beeps are emitted to confi rm that the change has been done and the display shows your new remote access code
digit per digit.
TWIST 366 ANSWERING MACHINE
Note
: This remote access code is different from the base PIN which is used to register / unregister handsets.
