38
MACH 1040
Release 02 03/2013
Configuration via BOOTP
Configuration via DHCP (Option 82)
AutoConfiguration Adapter
Further information on the basic settings of the device can be found in the
“Basic Configuration” user manual on the CD ROM.
Default settings
IP address: The device looks for the IP address using DHCP
Password for management:
Login: user; password: public (read only)
Login: admin; password: private (read and write)
Parameters that can be set via the management are set to pre-defined
values in accordance with the MIB
V.24 data rate: 9,600 Baud
Ring redundancy: disabled
Ethernet ports: link status is not evaluated (signal contact)
Optical 100 Mbit/s ports: 100 Mbit/s, full duplex
All other ports: autonegotiation
Ring manager disabled
Stand-by coupling: disabled
Port 4 = control port, port 3 = coupling port for red. Ring coupling
USB interface
The USB socket has an interface for the local connection of an
AutoConfiguration Adapter (part number ACA 21-USB see on
page 48
). It is used for saving/loading the configuration and for
loading the software.
V.24 interface (external management)
The V.24 interface is an RJ11 socket.
At the V.24 connection, a serial interface is provided for the local
connection of an external management station (VT100 terminal or PC
with corresponding terminal emulation). This enables you to set up a
connection to the Command Line Interface (CLI) and to the system
monitor.
Figure
Pin
Operation
1
VCC (VBus)
2
−
Data
3
+ Data
4
Ground (GND)
Table 5:
Pin assignment of the USB interface
1
2
4
3
Summary of Contents for HIRSCHMANN MACH 1040 Series
Page 51: ...MACH 1040 Release 02 03 2013 51...
Page 52: ......
