Belden HIRSCHMANN MACH 1040 Series, User Manual

Page: 37 / 52

MACH 1040
Release 02 03/2013
37
Applies to software release 06.0.00 and higher:
If the manual adjustment is active on the “relay” signal contact, then the
error display is independent of the setting of the signal contact.

Port state
The green and yellow LEDs at the individual port display port-related
information. During the boot phase, these LEDs are used to display the
status of the boot procedure.
2.3 Basic set-up
The IP parameters must be entered when the device is installed for the first
time. The device provides the following options for configuring IP addresses:
 Entry via V.24 connection
 Entry using the HiDiscovery protocol via the HiDiscovery or Industrial
HiVision application
LED Display Activity Color Meaning
R1 Signal contact 1 Lights up Green The signal contact is open in non
manual operation.
Yellow The signal contact is open in
manual operation.
None The signal contact is closed.
R2 Signal contact 2 Lights up Green The signal contact is open in non
manual operation.
Yellow The signal contact is open in
manual operation.
None The signal contact is closed.
LS, DA - link status, data
(one green/yellow LED or one green and one yellow LED per port)
Not glowing No valid connection.
Glowing green Valid connection.
Flashing green (1 time a period) Port is switched to stand-by.
Flashing green (3 times a
period)
Port is switched off.
Flashing yellow Receive data / send data.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
ETHERNET Service Port
1
2
3
4
MAR1040, MAR1042, MAR1140, MAR1142 MAR1140, MAR1142