Belden HIRSCHMANN IT MAMMUTHUS MTM8000 Series, User Manual

Page: 49 / 65

49
Install MAMMUTHUS switch
Issued in December, 2020
 Seal the SFP transceiver with protective cover.
6.4 Remove engine or medium module
Operate in the following steps:
 Untighten the screws on the front panel of the engine or medium
module.
 Press the locking lever outward to release the locking of the engine or
medium module (steps 1 and 2 ).
 Pull the engine or medium module out of the slot (step 3 ).
 Use the cover plate to seal the slot of the engine or medium module on
the basic device.
 Fix the cover plate with two (2) screws on the basic device.
You may check the tightening torque in "General Technical Data" on Page
50
6.5 Remove the device
Warning
Electric shock
Disconnect all other cables and then disconnect the earth wire.
Failure to observe this guideline might result in severe injury or
death or device damage.
Operate in the following steps:
 Disconnect the data cable.
 Disable the power voltage.
 Disconnect the power line.
 Disconnect the earthing wire.

To remove the device from the switch cabinet or wall, it is required to