Belden HIRSCHMANN IT MAMMUTHUS MTM8000 Series, User Manual

Page: 42 / 65

42
Install MAMMUTHUS switch
Issued in December, 2020
Operate in the following steps:
 Assemble the sliding or mounting guide rail into 19" switch cabinet
according to the regulations of the manufacturer.
 The device is installed on the guide rail of the switch cabinet.
Tighten the bracket onto the switch cabinet with the screws, to fix the
device.
 •
Installation on the vertical and flat surface
Warning
Fire hazard
In case of vertical installation, install the device in the fireproof enclosure.
Failure to observe this guideline might result in severe injury or
death or device damage.
Operate in the following steps:

Use the pre-installed bracket, as shown in the figure below.
 In addition, connect two (2) brackets onto the back of the device.
 The auxiliary bracket is supplied as the accessory. Refer to
"Accessories" on Page 59.
 Tighten the bracket onto the wall with the screws, to fix the device.
 Device earthing
The device has the connection with the protective earthing wire.
The device is earthed by the earthing screw and power socket.
Operate in the following steps:
 Earth the device with the earthing screws
You may check the tightening torque stipulated in "General Technical
Data" on Page 50.
2.4 Install SFP transceiver (optional)
Prerequisite:
Only Hirschmann IT SFP transceiver is used.
Refer to "Accessories" on
Page 59.
Operate in the following steps:
 Take off the protective cover from SFP transceiver.