User’s Manual
7 / EN
Installation
1
2
3
1 Loosen all bolts with the tool supplied in the User Manual bag until they turn freely.
(C)
2 Remove transportation safety bolts by turning them gently.
3 Attach the plastic covers supplied in the User Manual bag into the holes on the rear panel.
(P)
C
NOTE
¾
Keep the transportation safety bolts in a safe place to reuse when the machine needs to be moved again in the future.
¾
Never move the product without the transportation safety bolts properly fixed in place!
3.4 Flush usage with the bench
59,5 cm
84,0 cm
1,4 cm
66cm
86 cm
60 cm
65,5 cm
20 cm
15 cm
20 cm
15 cm
60 cm
A
CAUTION
¾
Your machine should never be operated without the top plate.
¾
When the Washer-Dryer is placed under the bench, front of the machine should never be blocked by the
cupboard door.
¾
When the Washer-Dryer is placed under the bench, air vents must be bored into the left and right sides of the
cupboard.
C
NOTE
¾
Follow the above dimensions when installing the product under the bench. These dimensions are indispensable to avoid
any change in the performance of your machine.
¾
Drying washing machine can be used under a bench if the height of the bench allows.
¾
At least 3 cm clearance must be left between the sides and the back of the product and the wall when it is installed under
the bench or in a cupboard.
3.5 Connecting water supply
C
NOTE
¾
The water supply pressure required to run the product is between 1 to 10 bars (0.1 – 1 MPa). It is necessary to have
10 – 80 litres of water flowing from the fully open tap in one minute to have your machine run smoothly. Attach a pressure
reducing valve if water pressure is higher.
¾
If you are going to use the double water-inlet product as a single (cold) water-inlet unit, you must install the supplied blind
stopper to the hot water valve before operating the product. (Applies for the products supplied with a blind stopper group.)
A
CAUTION
¾
Models with a single water inlet should not be connected to the hot water tap. In such a case the laundry will
get damaged or the product will switch to protection mode and will not operate.
¾
Do not use old or used water inlet hoses on the new product. It may cause stains on your laundry.
