22 / EN
Washer-Dryer / User’s Manual
Installation
• If the length of the hose is too short, add an original extension hose. Length of the
hose may not be longer than 3.2 m. To avoid water leak failures, the connection
between the extension hose and the drain hose of the product must be fitted well
with an appropriate clamp as not to come off and leak.
3.6 Adjusting the feet
A
CAUTION
• Adjust feet so that the product will be balanced in the
location it will be used.
• Balance the machine by adjusting the feet.
• Check for any play by pressing the product from upper
diagonal edges.
• Otherwise, the product may move from its place and
cause crushing, noise and vibration problems.
• Do not use any tools to loosen the lock nuts. Otherwise,
the lock nuts may get damaged.
a) Loosen the lock nuts on the feet by hand.
b) Adjust the feet until the product stands level and balanced.
c) Tighten all lock nuts again by hand.
3.7 Electrical connection
Connect the product to a grounded outlet protected by a 16 A fuse. Our company
shall not be liable for any damages that will arise when the product is used without
grounding in accordance with the local regulations.
• Connection must comply with national regulations.
• The wiring for the electrical outlet circuit must be sufficient to meet the appliance
requirements. Use of a Groud Fault Circuit Interrupter (GFCI) is recommended.
• Power cable plug must be within easy reach after installation.
• If the current value of the fuse or breaker in the house is less than 16 Amps, have a
qualified electrician install a 16 Amp fuse.
