21 / EN
Washer-Dryer / User’s Manual
Installation
A
CAUTION
• Ensure that the cold water connection is made
correctly when installing the product. Otherwise, your
laundry will come out hot at the end of the washing
process and wear out.
2 Tighten the hose nuts securely by hand. Never use a tool when tightening the
nuts.
3 Open the taps completely after making the hose connection to check for water
leaks at the connection points. If any leak occurs, turn off the tap and remove the
nut. Retighten the nut carefully after checking the seal. In order to prevent the
water leaks, keep the taps closed when you do not use the product.
3.5 Connecting to the drain
• Attach the end of the drain hose directly to waste water drain, sink or bathtub.
A
CAUTION
• Your house will be flooded if the hose comes out of its
housing during water discharge. Moreover, there is
risk of scalding due to high washing temperatures! To
prevent such situations and to ensure smooth water
intake and discharge of the machine, fix the end of
the discharge hose tightly so that it cannot displace.
90 cm
90
40
90
40
90 cm
90 cm
min.40
• Connect the hose to a minimum height of 40 cm and a maximum height of 90 cm.
• If the hose is run along the floor (or at less than 40 cm above it) and raised later on,
water drain becomes difficult and laundry may come out extremely wet. Therefore,
observe the heights described in the figure.
• To prevent flowing of dirty water back into the machine and to allow for easy
discharge, do not immerse the hose end into the dirty water or do not drive it in the
drain more than 15 cm. If it is too long, cut it short.
• The end of the hose should not be bent, it should not be stepped on and the hose
must not be pinched between the drain and the machine.
