Page
8 ©
BEKA 2017 All rights reserved!
...a product of
5.
General safety instructions
All persons that are in charge with the assembly, start-up, maintenance and operation of the device must carefully read these
instructions. Furthermore, this manual must permanently be available at the site of operation!
Basic notes for setup, operation and maintenance can be found below.
5.1 Safety
instructions
Please observe the safety instructions within this main point as well as special safety instructions that are included in other parts of
this documentation.
Warning of electrical voltage.
Safety instructions, which in case of non-observance might cause hazards to persons, are marked with the general
danger symbol.
This symbol warns of hot surfaces.
Warning of suspended loads.
Warning of material damage due to electrostatic discharge! Marks potential risks which may result in material damage,
if not avoided.
This heading is used if the improper or general non-observance of the operating manual, specified work flow
and the like might result in device damage.
This term is used to point out particular details.
Instructions which are directly attached to the device have to be strictly observed and kept in readable condition!
5.2
Qualification and training of staff
The staff in charge for operation, maintenance, inspection and assembly has to have the according qualification for
these tasks. Competence, responsibility and supervision of staff must be clearly defined by the operator. In case the
staff does not have the necessary knowledge it has to be instructed and trained accordingly. The operator is obliged
to ensure that the staff fully understands the contents of this user information.
Notice!
Caution!
