BEKA BA627E-SS, Manual, Page: 8 / 18

4.5 Scale card
The Set Point Station's units of measurement are
shown on a printed scale card in a window at the
right hand side of the display.
The scale card is
mounted on a flexible strip that is inserted into a slot
at the rear of the instrument as shown in Fig 6. Thus
the scale card can easily be changed without dis-
mantling the indicator or removing it from the en-
closure in which it is mounted.
New instruments are supplied with a printed scale
card showing the requested units of measurement, if
this information is not supplied when the Set Point
Station is ordered a blank card will be fitted.
A pack of self-adhesive scale cards printed with
common units of measurement is available as an ac-
cessory from BEKA associates.
Custom printed
scale cards can also be supplied.
To change a scale card, unclip the protruding end of
the flexible strip by gently pushing it upwards and
pulling it out of the enclosure.
Peel the existing
scale card from the flexible strip and replace it with a
new printed card, which should be aligned as shown
below.
Do not fit a new scale card on top of an ex-
isting card.
Install the new scale card by gently pushing the flex-
ible strip into the slot at the rear of the indicator,
when it reaches the internal end-stop secure it by
pushing the end of the flexible strip downwards so
that the tapered section is held by the rear panel of
the indicator.
Align the self-adhesive printed
scale card onto the flexible strip
and insert the strip into the in-
dicator as shown below.
Fig 6 Inserting flexible strip carrying scale card
into slot at the rear of Set Point Station.
8