BEKA BA627E-SS, Manual, Page: 5 / 18

( While this button is pushed the
BA627E-SS Set Point Station will display
one of three alternatives depending upon
how the instrument has been configured:
Output current mA without bargraph
Output as a % of span
Pre-set outputs in engineering units
The display will flash. While continuing
to press the
( button, operating the
& or * button will show the identifica-
tion of the pre-set closest to the present
Set Point Station output, followed by the
pre-set value. Operating the
& or *
button will scroll through the five pre-
sets and an ‘Abort’ position.
Releasing both buttons will leave the
selected pre-set value or ‘Abort’ legend
flashing for ten seconds, during which
time operating the
) button will update
the Set Point Station output to the dis-
played pre-set value. If the
) button is
not operated during this period, the Set
Point Station output will not be changed
and the original engineering display will
be shown.
( + & Firmware number followed by version.
( + ) Access to configuration menu via optional
security code.
2.3 Displays
The BA627E-SS Set Point Station has a 5 digit dis-
play plus a 31 segment bargraph.
The digital display may be calibrated using the
CAL
or
5Et functions to display the engineering variable rep-
resented by the Set Point Station’s 4/20mA output,
such as temperature, pressure or speed.
The digital display shows the requested Set Point
Station output in engineering units, the digital display
will flash until the Set Point Station output is the
same as the requested output.
The bargraph, which is not adjustable, always shows
the actual Set Point Station output. The bargraph
starts and finishes at the two currents at which the
digital display was calibrated, usually 4 and 20mA.
See sections 5.4 and 5.5.
5