11
Display
Description of function
'Cond'
Indicator conditioning
This is a protected sub-menu
which contains the calibration
routine for the two internal
references 'rEF', and the mains
(line) frequency filtering function
'FrE'.
See section 5.9
CAUTION
Please read sections 5.9
and 5.9.1 of this manual
before changing any of the
parameters in this sub-
menu. Incorrect adjustment
may result in reading errors.
'CLr. Gtot' Clear grand total
This function resets the grand total
to zero when 'CLr YES' is selected,
and 'SurE' is entered to confirm the
instruction.
Note:
Once cleared, a grand total
can not be recovered.
See section 5.10
't-bASE'
Timebase
Three selectable divisors which
define whether the rate display
represents flow per second, per
minute or per hour.
See section 5.11 & Fig 6.
‘C - - P'
Function of
P
push-button in
display mode
The instrument may be
programmed to show on the rate
display the input current in
milliamps, or the input as a
percentage when the
P
push-
button is operated in the display
mode. Select ‘PC’ for % of span
and 4-20 to display current.
See section 5.12
Display
Description of function
'SCALE-t' Total Scale Factor
Defines the arithmetic relationship
between the rate and total
displays. May be adjusted
between 0.0001 and 65535
SCALE-t = Units of rate display
Units of total display
To calculate SCALE-t the required
units of measurement for the total
display must be converted to the
units of measurement used for the
rate display.
See section 5.13, 6 and Fig 6.
'CLIP-OFF' Percentage Clip off
To prevent totalisation at very low
flow rates, this function enables
the user to select a percentage
rate below which the rate display
is forced to zero. Adjustable
between 0 and 10% of flow for
linear inputs, and 5 to 10% when
the root function is used to
linearise a square law input.
See section 5.14
'LOC.rSEt' Local reset of total display
When turned 'On' this function
enables the total display to be
reset to zero by simultaneously
operating the
Up
and
Down
push-
buttons.
See section 5.15
'COdE'
Security code
Defines a four digit numeric code
which must be entered to gain
access to programmable
functions. Default code 0000
disables the security function and
allows unrestricted access to all
programmable functions.
See section 5.16
