44
45
Quick Start Guide
DIAMOND DOME DD610
IR Remote Control (Option)
When using the remote control, the space between the device and the remote control should be kept free of obstacles.
The remote control has a range of 10 meters.
Remote Control Battery
1.
The battery positive (+) should face as shown below.
2.
The arrow indicates the plastic lock.
Button
Function
ON/OFF
Press to turn unit on, press again to turn off
AUTO
Active Show, same as AU0 random
PRG
Active Show mode. Use + / - to select the preset program
from AU1 to 16
SOUND
Turn Sound Control On/OFF. When ON, press + / - to adjust
the sensitivity from 0 to 100 *
SPEED
Activates speed setting when AUTO and PRG mode is ON. Use
+ / - to adjust the speed from S001 to S099 *
STROBE
Activates strobe. Use + / - to adjust the speed from 0 to 100 *
+
Press to increase the current value to a maximum value of
100. Press - to decrease.
DIMMING
Dimmer can be used in AUTO mode, PRG mode, SOUND mode,
and static color.
-
Press to decrease the current value to a minimum value of 0.
Press + to increase.
W, A, UV, R,
G, B
Select color for dimmer mode (White, Amber, UV, Red, Green,
Blue)
1 to 9
Select preset color
Notes
* Each press of +/- increases/decreases by 1, but if held
down, the values change faster.
DMX Control
To use a DMX controller to control the device, you must first set the DMX address code. The address code range is
In this way the device can receive the DMX signals.
1.
Press the
MENU
button, select the
Menu option.
2.
Press
ENTER
button. The address code will flash. Use
UP/DOWN
to select
DMX
address code. Our factory value is set to
.
3.
After the address code is set, hold the
ENTER
button.
4.
Connect from the output of the DMX console to the
DMX
input of the first slave, and connect the DMX output of the first slave to
the
DMX
input of the second slave, and so on. Connect all the slaves.
DMX connection requires terminal (loop connection)
During the installation process, if the signal line is laid a long distance, or in a noisy environment, such as a dance hall, it is recommended
to use a DMX terminal (loop connection). This can reduce any interference to the digital control signal by electrical noise.
The DMX terminator consists of a simple XLR connector with pin 2 and 3 connected to a 120 Ω resistor. Please insert the terminator into
the XLR output port of the last device, please refer to the figure below.
