Beha-Amprobe GT-650, User Manual

Page: 59 / 108

GT-650/GT-900 User's Manual
59
How to create new (customer-created) AUTO-TEST, see also chapter “CREATE
AUTO-TEST” on page 72:
There are two ways

To create new AUTO-TEST from scratch step by step or

To copy one of existing AUTO-TESTS to a new location and then modify it.
Note!
When new AUTO-TEST is created regardless of selected region, it will be offered in
both regions.
AUTO-TEST modes
There are two AUTO-TEST modes available:

STANDARD mode
This mode is advised to be used when operator is starting with AUTO-TESTS in
generally in order to easily follow the AUTO-TEST procedure step by step. Each
new measurement has to be started with START button. Once the operator is
familiar with AUTO-TESTS, FAST mode is advised to be used.

FAST mode
This mode enables the operator to carry out AUTO-TEST quickly. The whole
AUTO-TEST procedure will be carried out automatically.
How to select AUTO-TEST mode:
See the description in section “AUTO-TEST MODE” on page 78.
REGION:
Select the region before starting with AUTO-TESTS. Region to be selected depends
on the country where the GT-650/GT900 tester is to be used, see more in SETUP /
REGION menu on page 76.
Compensation of test leads in R
PE
, R
PE
CORD and R
PE
PRCD test steps:
When carrying out AUTO-TESTS it is important to be aware that compensations
from single measurements are used in AUTO-TESTS too.

Currently active compensation in single R
PE
function is used in R
PE
AUTO-TEST
steps.

Currently active compensation in single CORD or PRCD functions is used in
CORD and PRCD AUTO-TEST steps.
Idle display explanation (present after switching rotary switch to AUTO position):
Figure 46: Idle display in AUTO function (example)
Note!
AP# = Appliance Code