Beha-Amprobe GT-650, User Manual

Page: 51 / 108

GT-650/GT-900 User's Manual
51
Protective Extra Low Voltage Test (PELV)
The test measures the protective extra low voltage between any accessible
conductive part of tested appliance and earth (PE).
Figure 42: PELV test connection
Display explanation:
Figure 43: Display in PELV test (example)
1 ...... “SELV/PELV” menu key for selection of measurement function
(SELV or PELV).
2 ...... “LIM” menu key for pass/fail limit value setting (standard values
are 25 or 50 V).
3 ...... Test result status ( ... result OK, X ... result not OK).
4 ...... Pre-set pass/fail limit value.
5 ...... Function selected by the rotary switch and the “SELV/PELV” menu key.
6 ...... Test result and unit.
Specific information that can be shown on the display
Information displayed Description
<10.0V PELV value lower than 10.0 V.
>100.0V
PELV value higher than 100.0 V, remove the
probe immediately.
☞
Warning!
Dangerous situation may arise if voltage higher than 100 V is applied to
probe 2, remove the probe immediately!

In order to save displayed measurement results, see the “Memorizing example”
section.