Beem DYNAMIC i-POWER, User Manual

Page: 31 / 80

27
EN DYNAMIC i-POWER
BEEM - Elements of Lifestyle
Troubleshooting
The following table will help you locate and eliminate minor faults:
Fault Possible cause Remedy
Control indicator
does not light up
Plug not inserted into
mains socket
Insert plug
No mains power
Check the mains socket or auto-
matic circuit breaker
Control indicator defective Contact customer service.
No steam or spray
shot
No water in the water tank Fill with water
Temperature too low for
steam
Set temperature regulator to
"MAX" and allow the appliance to
heat up
Steam switched off
Set the desired steam flow with
the steam flow regulator
Water drips out of the
ironing sole
Water tank too full
Empty some water out of the
tank
Temperature too low
Set temperature regulator to
"MAX" and allow the appliance to
heat up
Steam flow too high Turn back steam flow regulator
Steam shot button pressed
too often
Press steam shot button in
greater intervals