24
DYNAMIC i-POWER
EN
BEEM - Elements of Lifestyle
Restarting after interruption
When you let go of the handle (6) dur-
ing ironing, the appliance switches
itself off (automatic safety switch-off,
fig. B) and the control indicator (11)
flashes.
If you wish to continue ironing after
an interruption, grip the handle (6)
firmly: the control indicator (11) and
the temperature indicators (9) will light
up on both sides. The appliance starts
heating to attain the previously set
temperature. When the temperature
has been reached, the temperature
indicators extinguish. The control indi-
cator (11) lights up again until you let
go of the handle. It then begins flash-
ing again.
After using
Set the temperature regulator (13) to
the "OFF" position.
Pull the plug out of the mains socket.
Open the tank lid.
Hold the appliance over a wash basin
or similar and turn it upside down. The
water will now run out of the tank.
Empty the water tank each time after
using the appliance.
Clean the appliance as described in
the
Cleaning and care
section.
Steam shot
NOTE
The lower the temperature set, the
►
less steam is discharged from the
appliance and the longer the inter-
vals until steam is generated again.
Press the steam shot button (4) to dis-
charge a steam shot.
. Press the
button at intervals of a few seconds.
Spray function
NOTE
The spraying function is ideally suit-
►
ed for moistening stubborn creases
in cotton or linen.
Press the button (5)
so that the
appliance discharges a spray shot.
Summary of Contents for DYNAMIC i-POWER
