USER MANUAL FOR BEEM OUTDOORS, LLC. 20KW
SILENT STANDBY GENERATOR SET
20
For first time battery usage, follow the following steps:
● Remove the red cap from battery positive terminal.
● Check to see if the battery voltage is 12.6V or higher. Charge the battery if the
voltage is lower than 12.6V.
● loosen the positive battery connection from the engine and connect to the positive
battery terminal, adjusting the direction as needed.
● Fasten the nut on the positive battery connection. .
● Cover with the red rubber battery cover.
Th
e “+”and “-” on battery should connect the positive pole and negative poles
respectively on the engine. The connections should be tight. DO NOT connect them on
the opposite sides or damage the electrical equipment of engine may result.
8. Grounding wire.
The engine must be grounded to the ground before use. Tightly connect the
grounding wire terminal located on the outside of the generator to the ground using a
grounding rod. DO NOT remove or not connect this terminal to the ground.
Make sure that the grounding wire is large enough to carry enough current. The
diameter of grounding wire is 12mm
(
1/2 inch). We suggest using copper wire for the
grounding wire.
The grounding wire is NOT SUPPLIED as part of the generator unit before delivery.
Remove the rust-proofing coating from grounding terminal before connecting.
9. Preparation before starting the generator.
Check the following items carefully before starting the generator.