4
Assembly Instructions
Before You Start
Note the tools you will need before you begin.
Remove any packaging material or protective plastic from
components.
Check for damaged or missing parts, and consult your retailer if
necessary.
Mobile trolleys are optional. You should follow the separate instructions that came with the trolley
before assembling and installing your barbecue.
Check The Cross Lighting Channels
The cross lighting channels should already be in place. If they are not, or if they moved
during shipping, they need to be replaced as follows: place each cross-lighting channel
onto the back support panel as shown. The keyed tabs on the bottom of each cross-
light channel fits into the slots on the burner support rail. The cross lighting channels
are required for all models.
Check The Burners
The burners should already be fitted to the
barbecue. If they are not, or if they moved
during shipping, they need to be replaced as
follows:
Remove the retaining clip from the burners.
Fit the burners, open end first, over the stem
of the control valves at the front of the barbecue. Lower
the other end of the burner so the lug locates into the
corresponding hole at the rear of the barbecue.
Replace the retaining clips into the burner lugs so the
burners stay in position. You need to do this from behind the
barbecue, underneath the back panel.
Check Gas Type
Check with your local gas supplier to ensure that your barbecue gas category, and
information on the appliance data plate is correct for the gas supply in your country.
You will find the gas type label on the side of your barbecue. You should also refer the
technical information on the back of this manual. If your barbecue is of the incorrect
gas type or pressure, or if you are unsure, consult your dealer before going any further.
Phillips Head
Screwdriver
adjustable spanner/
wrench
DISBBQINS_CE_LS2_0805.indd 4
DISBBQINS CE LS2 0805.indd 4
17/08/2005 14:54:27
17/08/2005 14:54:27
