Becker Centronic UnitControl UCS520, Operating Instructions Manual

Page: 26 / 52

26
Operating Instructions
Default setting
Encoding switch setting:
1. Lower position Alarm signal function on
2. Lower position Drive controller
3. Lower position No function
Programming the intermediate position
Prerequisite: The sun protection system is at the fi nal retracted position.
1. Press and hold the intermediate position programming button
▼
.
2. Additionally press the EXTEND button until you reach the required intermedi-
ate position. Adjustments can be made using the RETRACT or EXTEND but-
ton.
3. Release the intermediate position programming button
▼
. The intermediate
position has now been saved.
The control light will briefl y light up 3 times.
Deleting the intermediate positions
Press the intermediate position programming button
▼
for longer than 5 sec-
onds. The intermediate position has now been deleted.
The control light will briefl y light up 3 times.
Programming the fabric tensioning position
Prerequisite: The sun protection system is at the fi nal extended position.
1. Press and hold the fabric tensioning position programming button
▲
.
2. Additionally press the RETRACT button until you reach the required fabric
tensioning position. Adjustments can be made using the RETRACT or EX-
TEND button.
3. Release the fabric tensioning position programming button
▲
. The fabric
tensioning position has now been saved.
The control light will briefl y light up 3 times.
Deleting the fabric tensioning position
Press the fabric tensioning position programming button
▲
for longer than 5
seconds. The fabric tensioning position has now been deleted.
The control light will briefl y light up 3 times.
Programming