IMPORTANT SAFETY INSTRUCTIONS
This device is designed to monitor only the sounds of your child. It will not alert you
to your child’s silent activities. This product is not designed or intended for use as a
medical device. Always be sure that both the transmitter and receiver are working
properly and are within range of each other. This monitor is not intended to replace adult
supervision of children.
1. Keep adapter cords and units out of the reach of children.
2. Do not use with extension cords.
3. Do not place the monitor inside the crib.
4. Use only with 110-Volt electrical outlets.
5. Allow for proper ventilation when in use.
6. Do not place the units in a drawer as this will interfere with the
transmission of sound.
7. Do not position monitor where it can get wet or near sources of heat
such as a radiator.
8. Do not immerse the monitor in water.
9. Place in a safe place and out of the reach of children.
10. Do not disassemble the units.
11. Use only 9-Volt batteries or the AC adapters provided.
PRODUCT CARE
Clean the exterior surface of the BébéSounds
®
Easy-to-Hold Sound Monitor with a soft dry
cloth. Do not use sprays or liquids of any kind. Never immerse in water.
USING VOICE ACTIVATION
Voice Activation eliminates the background “hum” associ-
ated with sound monitors when there is no significant
sound being transmitted from your baby’s room. It does
this by automatically placing both the Nursery Unit (transmitter)
and the Parents’ Unit (receiver) into a “standby” mode. When sig-
nificant sound is detected, the Voice Activation automatically
returns both units to an “active” mode and immediately transmits
your baby’s sounds to you.
You can determine how sensitive you want the Voice Activation
feature to be. For example, if you want to hear the slightest
sound in the nursery, adjust the sensitivity on the Voice Activation
dial on the Nursery Unit to the maximum level (See Fig. 5). If you
only want to hear when your baby cries, adjust the sensitivity to a
lower level. You may have to adjust the sensitivity level a couple
of times until you get the exact level you want.
Remember
, when using the Voice Activation feature you may think
the sound monitor is not working because the monitor is com-
pletely quiet and you don’t hear a background “hum.” Don’t
worry – the monitor is in a “standby” mode and will immediately
return to the “active” mode when your baby cries or makes
sounds. If you want to hear this “hum,” deactivate the Voice
Activation by switching it off on the Nursery Unit (See Fig. 6). The
Voice Activation controls are only on the Nursery Unit, not on the
Parents’ Unit.
7
6
Fig. 5
Fig. 6
49MHz-Manual 10/17/05 11:25 AM Page 6
