BEBE CONFORT milofix, Manual, Page: 42 / 86

( )
( )
42
EN
• After putting your child in the seat, ensure that
the harness straps are properly tight. Also ensure
that the strap is not twisted.
• After putting the child in the car seat, ensure that
the harness is sufficiently taut by pulling the belt.
Ensure also that the belt does not become
twisted.
WARNING:
never combine two ISOFIX anchorage and car seat belt
systems to install your child car seat.
ATTENTION:
in ISOFIX use the fitting clips for lower anchorage to the
vehicle is not sufficient. It is essential to fix the “Top
Tether” to the upper anchorage point recommended by
the car manufacturer.
Fitting the MiloFix seat with additional tethers using the
vehicle’s ISOFIX additional anchorage points.
The ISOFIX anchors have been developed to obtain a
safe and easy fixation of the child safety systems
inside the car. Not all cars are equipped with these
anchors although they are standard on more recent
models. Consult the attached list of cars for which
the car seat can be installed correctly (you can also
consult additional updates of this list on the website
www.bebeconfort.com)
• In rear-facing position (GR0+), this product must not be
installed to places equipped with a frontal air bag. You
might be able to deactivate it (see your car manual). In
this case, if you can deactivate the air bag, you can use
the car seat on the front seat.
• In forward facing position (GR1), the seat must be
placed on the car rear seat or exceptionally on the front
seat in accordance with the legislation in force in the
country of use (In France: in accordance with the
conditions stipulated in decree n° 91-1321 du
27-12-1991). If you use the MiloFix on the front seat, it
should be possible to deactivate the airbag of the seat
in question or move the passenger seat back to a
maximum (Please consult your car manual).
• When installing the seat in the rear-facing position, the
belt of the top tether can turn one quarter turn
according to the position of the anchorage point. This
does not impair the proper operation of the product.
• When installing the car seat, it is necessary to remove
the headrest in order to put the top tether through
correctly.
• Warning: when installing the car seat, spaces between
the base of the car seat and the vehicle seat are possible
depending on the position of the anchorage points
within the vehicle.
• It is essential that the car seat be replaced after an
accident.
• The user must always check that any luggage and other
objects likely to cause injury to the occupant of the car
seat in the case of impact are properly secured.
• The rigid parts and the plastic sections of a child
restraint device should be positioned and installed in
such a way that they cannot, when the vehicle is being
used under normal conditions, become trapped under
a moving seat or in the vehicle door.
• Never modify the construction or the materials of the
car seat and the seat belt without consulting the
manufacturer.