20 / 32
REV. 01
4.4.1 GT VERSION
Do NOT LEAN on the turntable during this operation. Dust on turntable could
reach the operator’s eyes. For that reason, be careful as not to accidentally push
the inflating pedal while working
.
•
When the pedal located on the left side of the machine
body is pushed down to its intermediate position (B),
air is released from the airline gauge.
•
When the pedal (C) is pushed down completely, air is
released from the airline gauge with a powerful jet from
the nozzles located in the turntable clamps.
4.5
TURNTABLE LOCKING VALUE ADJUSTING
Fig. 13
The tire changer turntable is preset by the manufacturer on a middle range measure from 12” to 28”
ext.
(considering the rim outer side and) from 14” – 30”
int.
(if you lock the rim from inner side).
It is however possible to change this dimension range in case of need when working on larger or
small rims; it is enough to change the position of the 4 clamps are shown in the figures below.
The obtainable value starts from a minimum of 12”-26” ext. and 14”-28” int. until a maximum of 14”-
28” ext. and 16”-30” int.
To change the position, proceed as follows:
•
Unscrew screw (1) using an Allen wrench.
•
Remove the locking clamp (2) and the slide piece (3).
•
Align the slide hole with one of the guide holes (4) according to the locking dimensions you
want to set. Use the measurements below for reference.
It is important to perform the above-mentioned operation for all 4 clamps to
avoid any unbalance in the locking process.
