28
29
7.2 Carburetor adjustment
The carburetor is a vital part of the engine. Adjusting should be left to our
company authorized dealer with the professional knowledge, specialized
date, and equipment to do so properly.
7.3 Engine oil replacement
WARNING
• Avoid draining the engine oil immediately after stopping the engine.
The oil is hot and should be handled with care to avoid burns.
1. Place the generator on a level surface and warm up the engine for
several minutes.
2. Remove the screws (1) and then remove the cover (2).
3. Remove the oil filler cap (3).
4. Place an oil pan under the engine. Tilt the generator to drain the oil
completely.
5. Replace the generator on a level surface.
NOTICE
• Do not tilt the generator when adding engine oil. This could result in
overfilling and damage to the engine.
6. Add engine oil to the upper level.
Recommended engine oil: SAE SJ 15W-40
Recommended engine oil grade: API Service SE type or higher
Engine oil quantity: 0.5L
7. Wipe the cover clean, and wipe up any spilled oil.
NOTICE
• Be sure no foreign material enters the crankcase.
8. Install the oil filler cap.
9. Install the cover and tighten the screws.
7.4 Air filter
1. Remove the screws (1), and then remove the cover (2).
2. Remove the screw (3) and then remove the air filter case cover (4).
3. Remove the foam element (5).
4. Wash the foam element in solvent and dry it.
5. Oil the foam element and squeeze out excess oil.
The foam element should be wet but not dripping.
NOTICE
• Do not wring out the foam element when
squeezing it. This could cause it to tear.
6. Insert the foam element into the air filter case.
TIP:
Be sure the foam element sealing surface
matches the air filter so there is no air leak.
3
4
3
MAINTENANCE
MAINTENANCE
