BDV CXPS, User Manual

Page: 104 / 128

R S - 2 3 2 A N D 1 0 / 1 0 0 T P R O T O C O L
CXPS Command Set
98
Reference Edition 1.07 CXPS Manual
DISDEL DISDEL <output #>
Removes dissolve settings, resetting the output
parameters to defaults.
DISFF DISFF <output #> Special Command. Performs the Dissolve FlipFlop
effect: after the dissolve effect is completed, the
original content of the output will be switched to
the source output.
<output #> must be the same as in setup.
NOTE: The DISFF command can only be used
when dissolving between two output channels that
are NOT under windowing mode. These channels
must be connected to display screens.
SDO SDO <preset #> <dissolve
rate> <output #> <from
source> ... <output #>
<from source>
Sets up the simultaneous dissolve output window
pairs.
<preset #>
refers to the preset slot (1-32) to
which you would like to store the dissolve pairs.
<output #> is the output or window whose video is
gradually replaced by the video from <from
source>.
<output #> is the number (1-36) of the output
channel connected to the window/output you
would like to select.
<from source> is the number (1-36) of the output
channel connected to the window/output you
would like to select, or the number 100 for black.
<dissolve rate> is the number of frames (1-1024)
for the dissolve transition.
SDODEL SDODEL <preset #>
Removes simultaneous dissolve settings.
SDORUN SDORUN <preset #>
Performs the simultaneous dissolve effect using
the preset window pairs.
SCALING COMMANDS
Command Syntax Action
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CKOFF CKOFF <output #>
Turns off chromakeying.
CKON CKON <output #> <fg> <bg>
<red-lo> <green-lo> <blue-
lo> <red-hi> <green-hi>
<blue-hi> Turns on chromakeying and selects the color
within the specified range of RGB key values.
DBUFFER DBUF <output #> <threshold>
Changes the double buffer threshold value.e
FREEZE FZ <output #> <ON|OFF> Freezes selected output.
GAMMA GAMMA <output #> <value>
Changes the gamma of the selected output channel.
<gamma>
is a value from 10-250. 10 is equal to
gamma 0.1 and 250 is equal to gamma 2.5.
Default = 100, which equals gamma 1.0.
DISSOLVE AND FORCE COMMANDS
Command Syntax Action
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .